Soap Dish from bottom of 2 liter bottle

I was inspired by a post at Alessia's Scrap Craft to create my own version of the bottom of 2 liter plastic bottle into a soap dish, although I made mine taller.  Not only does it cost almost nothing to make, it keeps the soap from getting soggy and gross on the bottom.

Items used:

• 2 litter plastic bottle
• Kitchen shears, Xacto Knife, box cutter or some other method to cut the bottle
• Rhinestones 
• E6000 or other strong clear glue

1. Decide how tall you want your soap dish to be.  I used a line that was already on the bottle below the label for a guide.
2. Cut the bottom off of the bottle (I used kitchen shears as I found I have better control over keeping the even, to start the cut, pinch the plastic slightly, cut, then insert one of the blades inside the bottle).
3. Glue rhinestones around the edge - I alternated blue and clear about and put them the length of 2nd bend in my index finger as a rough guide, but you could glue them wherever you wanted.

Happy crafting!

Linking up to:
30 Days of Creativity

LARGE DRAGON EGG

Welcome to the first day of Monster Madness Blog Hop running from May 1 - 7th.  Check out the other participants at the link at the bottom.
My first project is a dragon egg that you can make out of an empty 2 liter bottle. 

-  1 empty 2 liter plastic bottle, rinsed and label removed
-  Scissors, Xacto knife, hot blade or box cutter & Sharpie
-  Duct Tape
- Glue Gun and Hot Glue Sticks
-  Spray Paint (black) and Glitter Glue (gold)

I used this to hold a small present for my son for Easter - it does make a unique package!  He uses it to hold miscellaneous items. 

The first step in making it is to measure up 4 inches from the bottom of the bottle and mark using a Sharpie.  Cut the top off the top of the bottle (I used a hot knife) then measure 3 1/2 inches down and mark with a Sharpie.  Cut along the lines (I used a pair of scissors as it allows better control).  It will look like the pieces below when you are done.

Cut a small square of duct tape, enough to cover the opening on the top.

Put the top inside the bottle and an angle and wiggling it until it fits snuggly, the use the hot glue gun to give it texture.  On the very top I put swirls on the tap and down about and inch then made oval shapes all the way around and added other squiggles in the middle, but don't cross over to the bottom of the bottle.   On the bottom I mostly did different squiggles; on this too, don't cross over to the top of the bottle.

I used a few coats of black spray paint on the outside, allowing it to dry between coats, but you could use any color that strikes your fancy.

After completely dried, I also then used glitter glue on mostly on the "veins" created by the hot glue gun  to give it sparkley, mystical look, but it you could omit it if you wanted a different look.